Multiple Choice Questions

I took the exam today, got 1000. The only questions I saw were the ones from November.

Thanks a lot Choobs!!!

I did the exam today and got 1000 as well. Multiple questions were from the November set only. Do not bother with the other set of multiple questions! Both HSRP and BGP Simlet were in the exam and most of the 17 tickets.

Same topologies, same questions as well. No surprises :)

Hi Guys, someone could help me to know where find the mcq of november. Do I need to have premier membership.

Hi friend some help me where find the MCQ of November.

Hey:
PDF: https://www.mediafire.com/file/ffy9dpfwwvztf24/TSHOOT_Nov_2019.pdf

Thanks a lot Drinu89!!!

Hi GS,
Yes, you need to have Premium Membership of Networktut.
Contact me to get share MCQ of November: saaau_holo(at)yaaahoo.com (replace aaa=a)

Passed today with 92x score:)
Everything for 300-135 to pass is available in this site.
Thanks networktut.com…
Guys just try to practice T-shoot lab which is available in this site, via packet tracer

Bahadurshah Multiple Choice which I see .. Please advice..I enroll next Saturday. Thank

I passed today with 980. Thanks networktut!

Multiple Choice Q which one need to prepare?

I passed with perfect score. All questions came from here. If you feel like the ticket isn’t from here check all the devices. The exam got a lot of bugs. So it could ruin your techniques. The MCQ all came from november. For BGP sim just enter the required codes you do not need to save it.Goodluck guys.

Hi, Im studying for CCNP Tshoot exam, I scheduled it for Saturday Feb 22nd. Can you please share any study material for the questions mr_chavezj(at)hotmail(.)com. Also, Can you please tell me if I need to study ALL questions listed or only the 12 questions from Nov13th update??

please tell me!
can i do premium sim by ipad?

All the MCQs from NOV 2019 set

green: no. They need flash. iPad won’t run flash so you will see only blank pages.

i see.
thanks ano!

Please share the MCQs/DD only, just one day to exam! Would be a great help at the last moment, plz share email. Thanks!

Passed tshoot with flying colors. Almost aced it. One new MCQ question although similar to Nov MCQ(hint: just make sure to know the difference between spanning tree port priority and spanning tree cost).

Everything else are the same regarding SIMs and Tickets. Well that’s it for now, Hope everyone gets what they want.

BTW. To those who haven’t booked the exam, better do it now. Do not procrastinate because most Pearson Vue testing centers are fully booked.

Good luck to all!!!!!

:)

Only 3 days for the last chance to final CCNP before Cisco change new Certifications. No more time, get dump and take exam ASAP.
@Contact me to get share all (VCE, PDF, PKT, UNL) with VCE tool player and all lab sim on EVE, Packet Tracer: saaau_holo(at)yaaahoo.com (replace aaa=a)
@@@D&D
Q1: Follwing the buttom-up TShoot methods, please order from step 1 to step 4 how to solve an issue with an IP phone:
Step 1. Confirm that enough power is received by using PoE
Step 2. Confirm that the phone is on the correct VLAN
Step 3. Verify the DHCP server configuration and option 150
Step 4. Verify the configuration the file from the TFTP serverver

Q2: Drag and drop questions to correct GRE configuration: (case 1)
R1 (10.1.1.1)=============R(CA)=============R2 (10.1.2.1)

R1(config)# interface Tunnel0
R1(config-if)# tunnel mode gre ip
R1(config-if)# ip address 10.1.3.1 255.255.255.0

R2(config)# interface Tunnel0
R2(config-if)# tunnel mode gre ip
R2(config-if)# ip address 10.1.3.2 255.255.255.0

Answer:
R1:
  Configure the tunnel source to be 10.1.1.1
  Configure the tunnel destination to be 10.1.2.1
R2:
  Configure the tunnel destination to be 10.1.1.1
  Configure the tunnel source to be 10.1.2.1

Q3: Drag and drop questions to correct GRE configuration (case 2):
R1 (192.1.1.1)=============R(CA)=============R2 (192.1.2.1)

R1(config)# interface Tunnel0
R1(config-if)# tunnel mode gre ip
R1(config-if)# ip address 10.1.1.1 255.255.255.0

R2(config)# interface Tunnel0
R2(config-if)# tunnel mode gre ip
R2(config-if)# ip address 10.1.1.2 255.255.255.0

Answer:
R1:
  Configure the tunnel source to be 192.1.1.1
  Configure the tunnel destination to be 192.1.2.1
R2:
  Configure the tunnel destination to be 192.1.1.1
  Configure the tunnel source to be 192.1.2.1

@@@MCQs
Q1: B. ipv6 traffic-filter INTERNET {in|out}
Q2: A. sh ip interface
D. sh ip traffic
Q3: A. Normal network traffic experiences asymmetric routing
Q4: E. 60 permit tcp host 2002:ABC:2000:2:2::2 host 2000:ABC:20:2:2::2 eq 22
Q5: A. set the exec-timeout 0 0 command on line con 0
Q6: A. EXSTART
Q7: D. DSW-01(config)#interface gig1/2
DSW-01(config-if)#spanning-tree cost 5
Q8: A. There are different VTP domain for S1 and S2
Q9: A. Recursive routing
Q10: A. On R2, change the tunnel source to 10.1.2.1
B.On R1, change the tunnel source to 10.1.1.1

Hello Guys,

took exam today got 1000/1000 all of ticket are validli got 9 ticket 2 Simulation(BGP and HSRP) and 13 MCQ. just be care IPV6 questions (If you can ping every 209.65.200.241-226-255 and 10.1.1.1-10 and 10.1.4.5-6 so here you go that is IPV6 ticket)

OSPF Authentication
NAT ACL
VLAN filter (Note: After choosing DSW1 for Ans1, next page (for Ans2) you have to scroll down to find the VLAN ACL/Port ACL option. The scroll bar only appears in this ticket and is very difficult to be seen.)
Switchport trunk
Redistribution Route-map
Ticket 12 – IPv6 OSPF
DHCP Helper-address
EIGRP Passive Interface
IPv6 GRE Tunnel

MCQ same as everybody motioned already.
Q1: Follwing the buttom-up TShoot methods, please order from step 1 to step 4 how to solve an issue with an IP phone:
Step 1. Confirm that enough power is received by using PoE
Step 2. Confirm that the phone is on the correct VLAN
Step 3. Verify the DHCP server configuration and option 150
Step 4. Verify the configuration the file from the TFTP serverver

Q2: Drag and drop questions to correct GRE configuration: (case 1)
R1 (10.1.1.1)=============R(CA)=============R2 (10.1.2.1)

R1(config)# interface Tunnel0
R1(config-if)# tunnel mode gre ip
R1(config-if)# ip address 10.1.3.1 255.255.255.0

R2(config)# interface Tunnel0
R2(config-if)# tunnel mode gre ip
R2(config-if)# ip address 10.1.3.2 255.255.255.0

Answer:
R1:
Configure the tunnel source to be 10.1.1.1
Configure the tunnel destination to be 10.1.2.1
R2:
Configure the tunnel destination to be 10.1.1.1
Configure the tunnel source to be 10.1.2.1

Q3: Drag and drop questions to correct GRE configuration (case 2):
R1 (192.1.1.1)=============R(CA)=============R2 (192.1.2.1)

R1(config)# interface Tunnel0
R1(config-if)# tunnel mode gre ip
R1(config-if)# ip address 10.1.1.1 255.255.255.0

R2(config)# interface Tunnel0
R2(config-if)# tunnel mode gre ip
R2(config-if)# ip address 10.1.1.2 255.255.255.0

Answer:
R1:
Configure the tunnel source to be 192.1.1.1
Configure the tunnel destination to be 192.1.2.1
R2:
Configure the tunnel destination to be 192.1.1.1
Configure the tunnel source to be 192.1.2.1

@@@MCQs
Q1: B. ipv6 traffic-filter INTERNET {in|out}
Q2: A. sh ip interface
D. sh ip traffic
Q3: A. Normal network traffic experiences asymmetric routing
Q4: E. 60 permit tcp host 2002:ABC:2000:2:2::2 host 2000:ABC:20:2:2::2 eq 22
Q5: A. set the exec-timeout 0 0 command on line con 0
Q6: A. EXSTART
Q7: D. DSW-01(config)#interface gig1/2
DSW-01(config-if)#spanning-tree cost 5
Q8: A. There are different VTP domain for S1 and S2
Q9: A. Recursive routing
Q10: A. On R2, change the tunnel source to 10.1.2.1
B.On R1, change the tunnel source to 10.1.1.1

Hello guys, I passed with score 9xx today

– 12 MCQ here only + 1 question about IPv6 Access List to access R4 to R3 SSH
– 2 Sim (HSRP, BGP simlet) You will need configure BGP. alphaeducation.com/download/exam/300-135.pdf
– Tickets

Everything you need is here in NetworkTut
Thank you!

@Jeff
Congratulations and thanks!

Hi all,

I passed today 961/1000

Everything here, 100% valid.

MCQ only the ones from November appeared to me. Didnt get a single unknown question.

Thanks Networktut

i passed today 1000 score!

Which MCQs to learn ? only November Questions or all ?

I passed today. 903/1000. November 13th questions are the only ones on the test. However my question 3 was a little different. I was asked to make G1/2 the new root port and the cost of G1/1 was 1.

Nikken, MCQ was the same as some guys mentioned h here

Pass in 22 with 1000/1000
Thanks network tut